Article

The 0290 valve is a servo-assisted solenoid valve of the S.EV series. The valve opens without differential pressure.

Type 5406 valves are pilot-controlled solenoid valves with servo pistons. Depending on the version, these valves can be used either as feed line or circulation valves. The valves fulfill the requirements of a safety shut off valve according to DIN EN 23553-1. It is approved by TÜV-Süd and certified by DIN Certco. The universal coil system reduces logistics and service expenses.

Energy Isolation - Lockout Valves, Safety Exhaust Valves for Non-Clutch/Brake Applications, Safe Cylinder Return Valves, and Load Holding Valves

Air Distribution manifolds provide individual control on machinery with multiple pneumatic circuits. Mechanical presses may have clutch/brake, counterbalance, die cushion, mechanical devices and automation valves circuits. Air distribution manifolds allow centralized independent pressure control as well as independent lockout points for each circuit.

The electronics Type SE56 (blind in compact version or with display in compact or remote version) connected to the magnetic flow sensor fitting Type S051, S054, S055 or S056 is designed for applications with liquids with a minimum conductivity of 5 μS/cm.

The Inline flow sensor/switch Type 8010 is specially designed for use in pure and water resembling fluids, free from air bubbles and magnetizable particles, to monitor minimum/maximum values of flow.

The fitting can be used to connect any Insertion device for a measurement in the pipe. e.g. for flow, pH, oxidation reduction potential (O.R.P) and conductivity measurement.

The sensor-fitting S030 has a built-in paddle wheel to measure the flow rate. When liquid flows through the pipe, the paddle wheel is set in rotation producing pulses which frequency is proportional to the flow rate

The complete full bore magflowmeter Type 8056, which consists of a magnetic sensor fitting Type S056 connected to an electronics Type SE56 (blind in compact version or with display in compact or remote version) is designed for applications with liquids with a minimum conductivity of 5 μS/cm.

The robust and compact positioner is designed to standardisation acc. to IEC 60534-6-1 or VDI/VDE 3845 (IEC 60534-6-2) for assembly with linear and rotary actuators. In addition, the remote version with the displacement position sensor can be combined with Bürkert process control valves.

Manually-operated angle-seat valve of the type series 2000/2702 are delivered as standard with threaded or weld end port connection. Type 2000 with manual actuator without position indicator is used only for On/Off function.